Thank you Perehama for your help, looking into this. I have up to now had no problems with all the code for other projects i have used the Arduino uno for, but this is bit above my paygrade, to sort, my back ground is electronics not software I world like to learn though.Īny help or pointers would be helpful Thanks Tony Smith
ARDUINO RADIO CLOCK SERIAL
I can load some of DCF77 German code dsf77_xal and view on the serial monitor, but not sure if it works as it show or not as I have the MSF UK timecoded data I have tried other old versions of IDE like 1.6.1 and1.6.3 with similar results, so now back to latest 1.18.13 on Windows 10 The first code I tried was from Jarkman, it's his MSF time receiver, when I load this it callup an error "minute" was not declared in this scope, red highlighted over the piece of code printDigits(minute()) What I wish to end up with is a Atmega 328 chip I can use to display time from the receiver viewed on a LCD16x2
I have seen the data output from the receiver, which 60 seconds packets of BCD all looks fine, I then feed this signal into my Arduino on analog pin 5, as requested by the code i have tried to load. My Arduino is Uno with Amega 328 micro controller.
So to continue The MCM -RS232 is not now in circuit as I took it to try and make the units more simple, as I do not yet need the RS232 to TTL convertorĪll these units came for Galleon Systems so have the receiver and ferrite antenna connected and working off MSF Anthorn. Sorry seem to have lost parts of my pervious reply
0 kommentar(er)
